Home - Return to Previous Page
BDS 7 Inch Lift Kit w/ 4-Link FOX 2.5 Performance Elite Coil-Over Conversion Ford F250/F350 Super Duty (20-22) 4WD Diesel (1985FPE)
This image is a representation of the product only. Actual product may vary in appearance.
BDSK-BDS1985FPE
Available
Item sold as a kit. call 800-365-8610 for component availability.
Pricing:
$8,357.93
Prop 65 Notice
ATTENTION STATE OF CALIFORNIA CONSUMERS: *WARNING* Cancer and reproductive harm-www.p65warnings.ca.gov
Important Notes
Ford recommends the replacement of the pitman arm nut after each time it has been removed.
Use a small pitman arm puller to remove the drag link joint and steering stabilizer taper.
If your truck is equipped with a factory rear sway bar add: BDS123808
If your truck is equipped with a 2-piece rear driveshaft, a Carrier Bearing Drop Kit may be required: BDS123402.
Due to the taller factory ride height, Tremor models will not net the full advertised lift height. The final ride height will be the same as standard models.
Larger tires on the stock wheel are not recommended due to the brake line clearance required. Use recommended specs listed in the wheel and tire fitment section.
The indexing ring is only compatible with 10-speed transmission trucks. Please verify your truck's equipment before installing it. The transfer case indexing ring will not fit 6.2L vehicles equipped with the 6R100 transmission.
Indexing Ring has NOT been designed to work on manual shift transfer case models. Modification of the shift cable mount will be required.
Installation requires a torque wrench capable of 405 ft-lbs.
Fits SRW models only.
Use a small pitman arm puller to remove the drag link joint and steering stabilizer taper.
If your truck is equipped with a factory rear sway bar add: BDS123808
If your truck is equipped with a 2-piece rear driveshaft, a Carrier Bearing Drop Kit may be required: BDS123402.
Due to the taller factory ride height, Tremor models will not net the full advertised lift height. The final ride height will be the same as standard models.
Larger tires on the stock wheel are not recommended due to the brake line clearance required. Use recommended specs listed in the wheel and tire fitment section.
The indexing ring is only compatible with 10-speed transmission trucks. Please verify your truck's equipment before installing it. The transfer case indexing ring will not fit 6.2L vehicles equipped with the 6R100 transmission.
Indexing Ring has NOT been designed to work on manual shift transfer case models. Modification of the shift cable mount will be required.
Installation requires a torque wrench capable of 405 ft-lbs.
Fits SRW models only.
Specification
Front Lift Method : Coil-Over
Front Lift Height : 7"
Rear Lift Method : Block
Rear Lift Height : 5"
Shocks Included : Yes
Lift Height : 6-7.5"
Front Lift Height : 7"
Rear Lift Method : Block
Rear Lift Height : 5"
Shocks Included : Yes
Lift Height : 6-7.5"
Details
- BDSK-BDS1985FPE
- BDSK-BDS1985FPE
- BDS
- New
Categories
Shipping Information
- Item Requires Shipping